The Marshall DSL40CR is a 40-watt, 2-channel all-tube 1x12" combo amp. It features EL34 power tubes, a Celestion V-Type speaker, built-in digital reverb, and power reduction down to 20W. This unit has been very lightly used and is in pristine condition and priced to sell including the footswitch.
Marshall's DSL40CR is capable of conjuring an entire arsenal of British-flavored tones. Four ECC83s in the preamp section, in concert with the amp's Gain/Master volume arrangement, give you stunning tone-shaping mojo, and with two EL34s in the engine room, you have the volume to rule any club in the world. While sporting the same tubes, minus two EL34s, and the same feature set as the original DSL100, this little beast has critical upgrades that give you even more control over your sound, including a Resonance control that lets you dial in your preferred amount of low-end girth, a studio-grade digital reverb, High and Low power settings, and a bypassable rear-panel series effects loop. The Marshall DSL40CR also has a 2-way footswitch for channel switching and reverb on/off.
Marshall DSL40CR Features:
Capable of conjuring any classic Marshall sound — past or present
2 channels — Classic Gain and Ultra Gain
Each channel features 2 modes — Clean/Crunch and OD1/OD2, respectively
High and low power modes allow you to dial in appropriate volume for any setting
Line output with Softube cabinet emulation faithfully re-creates the sound of a Marshall 1960 Lead cabinet
Highly effective Resonance control tailors your low-end response
Refined EQ section gives you incredible tonal flexibility
Studio-grade digital reverb
Bypassable rear-panel series effects loop
Included 2-way footswitch for channel switching and reverb on/off