Two(2) Ender 5 plus 3d Printer+ 800w heaters - $270 (Mission Viejo)

Two(2) Ender 5 plus 3d Printer+ 800w heaters 1

Two(2) Ender 5 plus 3d Printer+ 800w heaters 1 thumbnail

condition: good

make / manufacturer: Creality

model name / number: Ender5 Plus

QR Code Link to This Post

These two Ender5 Plus units are kept in a sealed enclosure and physically and functionally in good condition, except both seem to have sticky heaters after I used PETG filaments. PETG did not melt enough and clogging the heaters. The temperature of the heaters goes up to 240deg, but you may need to clean or replace the heaters.

One unit has the original feeder, the other unit has a direct feeder.

The package includes two sets of 800w heater kit ready to install with heat isolation pads as well as cork boards. These have the mounting holes matched up with Ender5 build plates.

I also include an AC voltage controller and a used AC solid state switch.

All these for $270.
--

I just fixed the heater issue on the direct drive unit. As I suspected, the issue was not the heater, but the inside of the interconnect Teflon tube. It got rough by the edge of filaments, and it blocked feeding. I didn't touch the other one, but I suspect that it is the same teflon tube issue.

post id: 7908621538

posted: 2026-01-14 09:41

updated: 2026-01-14 12:42

♥ best of ^[?]

reading

writing

saving

searching

refresh the page.

Two(2) Ender 5 plus 3d Printer+ 800w heaters - electronics - by...

These two Ender5 Plus units are kept in a sealed enclosure and physically and functionally in good condition, except both seem to have sticky heaters after I used PETG filaments. PETG did not melt...